Turbine blades in aircraft engines and land-based gas turbines are exposed to harsh environmental conditions that make them susceptible to […]
Filter by categories
November 11, 2024
Microstructural Analysis And Tribological Characteristics Of Thermally Sprayed Co-Ni-O Ternary Oxide Coatings
Due to their high thermal and chemical stability, ternary oxide coatings have been extensively investigated as potential solutions for high-temperature […]
August 26, 2024
Investigation on In-Flight Heating Process of Cerium Oxide Powders in Radio Frequency Thermal Plasma Considering Thermal Resistance Effect
In-flight heating process of powder particles in radio frequency (RF) thermal plasma have great importance for plasma spraying and spheroidization. […]
July 10, 2024
Role Of Powder Morphology On Α-Phase Content In Plasma Sprayed Alumina Coatings
Despite various studies addressing the retention of α phase in thermal sprayed alumina coatings, a noticeable research gap persists regarding […]
June 19, 2024
Impact Of Molten Salts Composition On The Corrosion Behavior Of Nimocr And Conicral Coatings On L-PBF 316L Stainless Steel For CSP Plants
The high-temperature corrosion performance of NiMoCr and CoNiCrAl coatings produced by high velocity oxy-fuel (HVOF) on laser powder bed fusion […]
May 10, 2024
Microstructure and Adhesion Strength of Ti Cold Spray Splats: The Influence of Powder Morphology
Cold spraying is an emerging additive manufacturing technology that can be used to repair metals and alloys. The adhesion strength […]
May 10, 2024
Influence of Deposition Parameters on the Formation of Surface Cracks in Segmented Aps-Tbcs
Thermal barrier coating system (TBCs) prepared using the Air plasma spray (APS) method are widely recognized as the most prevalent […]
April 29, 2024
Understanding the Impact of Binary Plasma Gas Mixtures in Plasma Spraying
In plasma spraying, H2 or N2 is commonly added to the primary Ar plasma which may increase the specific enthalpy, […]
April 29, 2024
Development and Understanding of CMAS Coating on YSZ Using APS Technique
The ingestion of siliceous particulate debris into the gas turbine engines during operation caused the deposition of so-called CMAS (calcium-magnesium-alumino-silicate) […]
