The cold spray (CS) process has gained momentum as an additive manufacturing technology, due to its low processing temperatures. Computational […]
Filter by categories
September 22, 2025
Single-Particle Impact of Ti6Al4V and Ti-5553 in Cold Spray: A Novel Approach to Flattening Ratio and Selecting Johnson–Cook Model Parameters
The application of Finite Element Analysis (FEA) in cold spray (CS) provides valuable information about material deformation and stress distribution. […]
September 11, 2025
Validation Of Open Source Computational Fluid Dynamics Software For Shot Peening Applications
Shot peening is a well-established surface treatment that is widely used in industry for improvement of fatigue performance of metal […]
September 11, 2025
Generating Oxide-free Molten Metal Droplets by Air Plasma Spraying Enabled by Deoxidizer Addition to the Feedstock Powders
Thermal spray metallic coatings usually present a lamellar structure with limited lamellar interface bonding due to inevitable oxidation involved. Such […]
September 11, 2025
Shot Peening DEM-FEM Simulation Considering Shot Stream Expansion, Peening Intensity and Target Materials
Finite element (FE) simulation of shot peening has been widely applied to investigate the influence of the shot peening parameters […]
September 11, 2025
Effect of Gun Geometry on MCrAlX Coating Microstructure and In-Flight Oxidation Deposited by Low-Temperature High-Velocity Air Fuel
Aircraft gas turbine blades operate in aggressive, generally oxidizing, atmospheres. A solution to mitigate the degradation and improve the performance […]
September 11, 2025
Modeling Of The Shot Peening Of A Nickel Alloy With The Consideration Of Both Residual Stresses And Work Hardening
Shot peening of turbine disk engines is performed in the aerospace industry in order to enhance fatigue life. This surface […]
September 11, 2025
High Density Ceramic Shot For Peening Application
Ceramic shots are used in a large range of industrial peening applications, such as automotive suspension springs, transmission gears, aluminium […]
September 11, 2025
Influence Of Process Parameters On The Microstructure And Adhesion Of Glaze-Based Coatings
Developing coatings for specific applications involves several challenges, including the formation of defects and undesired chemical reactions during spraying, both […]
